Turn-key PCB assembly services in prototype quantities or low-volume to mid-volume production runs

The Fun of Developing Arduino-based Talking and Remote Thermometer

For the home hobbyists, life would be extremely boring without the existing of Arduino projects! If you’re looking for some interesting Arduino-based project, then you’ve came to the right place…

Guys, today you’ll have the opportunity to build up a fantastic Arduino-based Talking and Remote Thermometer. This project isn’t a hard task, especially for the professional home hobbyists.

By the way, you should prepare the following components:

  1. An Arduino (With one free analog input port);
  2. A Solderless Breadboard;
  3. A 10k resistor;
  4. A 10k NTC (Negative Temperature Coefficient) Thermistor.

It’s time to kickstart the project! First of all, you’ll need to use the Power (+5v), Gnd (Ground) and one of the Analog-in connectrors (Pin 0) on the Arduino. For your information, the Analog-in connectors are normally located near bottom right-hand corner of the board. Furthermore, you’ll notice that the Power connectors are situated just to the left of analog-in connectors!

After that, you’re going to set up the 10k NTC thermistor and 10k resistor on the breadboard. Before you ended up the project, please make sure that all connections between the Arduino and the Measuring circuit have been connected properly!

[..Source link..]

Bookmark the permalink.

Comments are closed.