Wishing you has a signal that will tell you to get some fresh air, after long hours of sitting in front your computer?
Well, we recommend you this Mac Compatible, “Break Timer”.
- Microcontroller board
- OS X Software
- Hardware that connecting to microcontroller
Note: For the microcontroller board, you need to go to this site. Click on the Mac OS X link, extract the file after downloading, and drag the folder to your Applications folder. Lastly, just install the board’s drivers.
Firstly, you must have two pieces of wrapping wire and strip the wires with wire striper about one inch of each end. Wrap one wire with wire wrapping around each of the pins at the sensor.
Then, strip an inch from the other end of each wire and wrap the end of the other wire to the short end of that pin.
After that, plug the end of the resistor into the hole on the Arduino Analog in 0, while male header into the hole marked 5V and others to GND.
Finally, connect it with USB A-to-B cable in between your Mac.